TM 5-3805-261-23-1
FRONT BLACKOUT DRIVE LIGHT MAINTENANCE - CONTINUED
0106 00
DISASSEMBLY
1.
Remove finishing washer (18) and lockwasher (19) from housing (1). Discard lockwasher.
NOTE
Three screws cannot be removed from door.
1
2.
Loosen three screws (5) and remove door (4).
2
3.
Remove and discard two gaskets (3 and 17).
4.
Remove lamp (2) by pushing in and turning left.
3
4
19
17
18
5
397-321
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0021 00.
ASSEMBLY
1.
Install lamp (2) in housing (1) by pushing in and turning right.
2.
Install two new gaskets (17 and 3).
3.
Position door (4) on housing (1) and tighten three screws (5).
4.
Install new lockwasher (19) and finishing washer (18).
INSTALLATION
1.
Loosely install two U-bolts (13), brackets (16), four washers (14), and nuts (15) on tube (12) and position as a unit on
top of front frame.
2.
Slide two brackets (16) under lips of front frame, align rounded end of tube (12) flush with right edge of frame and
tighten four nuts (15).
3.
Position blackout light (8) in straight level position on tube (12), connect wire assembly (9) and install new lockwasher
(10) and nut (11).
4.
Connect wire assembly (7) to back of blackout light (8).
5.
Install two new cable ties (6).
6.
Connect battery cables (WP 0125 00).
END OF WORK PACKAGE
0106 00-3
