TM 5-3805-216-20
BODY, CAB, HOOD AND HULL MAINTENANCE.
13-15.
Operator’s Panel Console. (Sheet 5 of 6)
INSTALLATION
9.
Position
grommet
(34)
and
harness
assemblies (32 and 6). Push through
opening in panel (38). Seat lips of grommet
(34, Figure 13-54) around edge of opening.
10.
Connect harness assembly (33) to harness
assembly (32).
11.
Install main circuit breaker (31), two nuts
(30) and screws (29).
12.
Install master disconnect switch (28), plate
(27), washer (26) and nut (25).
13.
Install four washers (24) and bolts (23).
14.
Install disc (22), bearing (21), lever (20),
washer (19), spring (18), seat (17), washer
(16) and nut (15) in panel (11, Figure 13-
53).
15.
Install plate (14), two washers (13) and
bolts (12).
16.
Position
panel
(11)
on
right
side
of
operator’s panel console.
Figure 13-54.
Figure 13-53.
13-59
