TM 5-3805-261-20
WIRING HARNESS MAINTENANCE. (cont)
7-133.
Disconnect Switch Cable. (Sheet 3 of 4)
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Install cable assembly (21, Figure 7-220) on
disconnect
switch
in
inner
operator’s
console.
2.
Install washer (20) and nut (19).
3.
Install clip (18) on cable assembly (21) in
inner operator’s console.
4.
Install washer (17) and bolt (16) and clip
(18) to frame.
5.
Install two clips (15) on cable assembly (21)
under right side of operator’s compartment.
6.
Install two washers (14) and bolts (13),
securing clips (15) to frame.
Figure 7-220
Go to Sheet 4
7-348
