REMOVAL - TM-5-3805-261-20

Disconnect Switch Cable - TM-5-3805-261-20_659

TM-5-3805-261-20 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
610

TM 5-3805-261-20 WIRING HARNESS MAINTENANCE. 7-133. Disconnect Switch Cable. (Sheet 2 of 4) REMOVAL 1. Remove nut (1) and lockwasher (2, Figure 7-218) from starting motor on right side of engine. NOTE All wire, cable and harness assemblies must be tagged before disconnecting to aid in installation. 2. Disconnect cable assembly (21). 3. Remove and discard straps (3 and 4). 4. Remove two bolts (5), washers (6) and clips (7) from inner right, rear frame. 5. Remove two nuts (8) and washers (9, Figure 7-219) from bracket assembly. 6. Remove clip (10) from hose. 7. Remove plate (11). 8. Separate two clamps (12) enough to pull cable assembly (21) through. 9. Remove two bolts (13), washers (14) and clips (15, Figure 7-220) from under right side of operator’s compartment. 10. Remove bolt (16), washer (17) and clip (18) from inner operator’s console. 11. Remove nut (19) and washer (20) from disconnect switch. 12. Remove cable assembly (21) from disconnect switch. Figure 7-219 Figure 7-220 Go to Sheet 3 Figure 7-218 7-347

Privacy Statement
Press Release
Contact