TM 5-3805-261-20
BATTERY MAINTENANCE. (cont)
7-112.
Battery Cables and Batteries. (Sheet 4 of 8)
REMOVAL (cont)
7.
Remove nut (9), washer (10) and wire
assembly (11) from starter solenoid on
starting motor assembly.
8.
Remove cable assembly (12).
9.
Remove bolt (13), washer (14) and clip (15)
from rear, left side of frame in engine
compartment.
10.
Remove bolt (16), washer (17) and clip (18,
Figure 7-170) from under left side of frame.
11.
Remove bolt (19), washer (20) and clip (21)
from top of differential case.
12.
Remove bolt (22), washer (23) and clip (24)
from left side of articulation area. Clip (24)
is mounted on inside of frame below front,
left corner of engine.
13.
Remove cable assembly (25).
14.
Remove two nuts (26), washers (27), clip
(28), plate (29) and pad (30, Figure 7-171).
15.
Separate cable assembly (48) from pad
(31).
16.
Remove two nuts (32), washers (33), clips
(34 and 35), plate. (36) and pad (37, Figure
7-172) from right side of articulation area.
17.
Separate cable assembly (48) from pad
(38).
Figure 7-170
Figure 7-171
Figure 7-172
Go to Sheet 5
7-274
