TM 5-3805-261-20
LIGHT SYSTEM MAINTENANCE.
7-84.
Vehicle Rear Signal Lights. (Sheet 4 of 4)
INSTALLATION
1.
Install bracket (24), two washers (23) and
bolts (22, Figure 7-126) on vehicle.
2.
Install clips (21 and 20), nut (19), washer
(18) and bolt (17) on bracket (24).
3.
Position housing (16, Figure 7-125).
4.
Connect wire assembly (15) to wiring
harness connector and attach to clip (21).
5.
Install housing (16), three lockwashers (14)
and screws (13).
6.
Install lamp (12). Insert, depress and turn.
7.
Install new gasket (11), amber lens
(10)
and three screws (9).
8.
Position housing (8, Figure 7-124).
9.
Connect wire assembly (7) to wiring
harness connector and attach to clip (20).
10.
Install housing (8), three lockwashers (6)
and screws (5).
11.
Install lamp (4). Insert, depress and turn.
12.
Install new gasket (3), red lens (2) and
three screws (1).
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 7-124
End of Task
7-205
