TM 5-3805-261-20
CHARGING SYSTEM MAINTENANCE.
7-5.
Alternator. (Sheet 5 of 5)
TESTING
1.
Install radio interference capacitor. Refer to
paragraph 7-137.
2.
Connect multimeter voltage leads to output
terminal and ground terminal on alternator.
WARNING
Only
a
qualified
operator
may
perform the next procedure. All other
personnel must clear the immediate
area. Failure to follow this procedure
may cause INJURY. If you are
injured,
seek
medical
aid
immediately.
3.
Start engine. Refer to TM 5-3805-261-10.
4.
Observe multimeter voltage in right rear
engine compartment. If voltage is not 27.5
+ 1, contact Direct Support.
5.
Install two washers (2) and bolts (1) in door
(3, Figure 7-3).
6.
Stop engine.
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 7-3.
End of Task
7-15
