TM 5-3805-261-20
HYDRAULIC SYSTEM MAINTENANCE.
15-19.
Hydraulic Control Levers. (Sheet 7 of 11)
INSTALLATION
1.
Install shaft (85), bearing (84), spacer (83),
bearing (82) and lever (81, Figure 15-45) on
right side of steering console.
2.
Install nut (80) and articulation knob (79).
3.
Connect linkage (78).
4.
Install lockwasher (77) and bolt (76).
NOTE
Control
levers
must
be
out
of
alignment
to
provide
adequate
clearance for installation of bolts.
5.
Install bearings (75 and 74) and lever (73,
Figure 15-44).
6.
Install nut (72) and centershift knob (71).
7.
Connect linkage (70).
8.
Install lockwasher (69) and bolt (68).
Go to Sheet 8
15-79
