TM 5-3805-261-20 HYDRAULIC SYSTEM MAINTENANCE. 15-22. Hydraulic Pump Assembly, Junction Block and Steering Control Valve Lines.  (Sheet 1 of 10) This task covers: a. Removal b. Cleaning c. Inspection d. Installation INITIAL SETUP: Applicable Configurations Personnel Required All Construction equipment repairer MOS 62B Tools General Mechanic’s Tool Kit: References Automotive (NSN 5180-00-177- TM 5-3805-261-10 7033) LO 5-3805-261-12 Test Equipment Special Environmental Conditions None None Materials/Parts General Safety Instructions Dry cleaning solvent, None Item 14, Appendix C Clean cloths, Item 39, Torques Appendix C All fasteners are tightened to Small tags, Item 41, standard torques.  Refer to Appendix C Appendix E. Detergent, Item 8, Appendix C Preformed packings, Item 2, 7, 9, 12, 14, 17, 20, 26, 50, 51, 52 Caps Plugs Troubleshooting References None Equipment Condition TM 5-3805-261-10 Vehicle parked on level ground. Parking/emergency brake applied. Equipment lowered to the ground. Engine stopped. Master disconnect switch off. LO 5-3805-261-12 Main hydraulic oil line brackets removed. Go to Sheet 2 15-101