TM 5-3805-261-10
SECTIONALIZATION FOR AIR TRANSPORT
THIS WORK PACKAGE COVERS
Disassembly, Driving the Rear Frame, Assembly
INITIAL SETUP
Personnel
Tools and Special Tools
Components of End Item and Basic Issue Items
Two
Equipment Conditions
Materials/Parts
Machine parked on level ground (WP 0002 00)
Rag, wiping (Item 15, WP 0022 00)
Parking/emergency brake applied (WP 0002 00)
Tag, marker (Item 16, WP 0022 00)
Pin, cotter (1)
Implements lowered to ground (WP 0002 00)
References
Engine off (WP 0002 00)
Battery disconnect switch in OFF position (WP
DISASSEMBLY
NOTE
Assistance from two Unit Maintenance personnel is required for these procedures.
Disassembly must be performed on a firm, level surface.
Whenever possible, return hardware, clamps, and bolts to the holes from which they were removed. Be
sure to tighten them enough so that they will not loosen from vibration.
1.
Notify Unit Maintenance to remove the Rollover Protective Structure (ROPS) from the machine.
2.
Notify Unit Maintenance to move two supports from front of machine to rear support brackets on rear of machine.
3.
Install six ROPS bolts and bushings on bottom of supports.
4.
Start engine and center blade and side shift cylinders (WP 0005 00).
5.
Position blade at a 90-degree angle to the frame and lower the blade to the ground. Apply slight downward pressure to
reduce front weight on the articulation joint.
6.
Shut down engine (WP 0005 00).
