TM 5-3805-261-10
SECTIONALIZATION FOR AIR TRANSPORT INTRODUCTION - CONTINUED
0018 00
TOOLS AND EQUIPMENT
1.
Tools and equipment required for sectionalization are stored in a tool box located on the front of the machine.
2.
BII tools (WP 0021 00) must also be used.
3.
The following table contains wrench sizes that are needed to complete the sectionalization procedure.
Bolt/Nut
Location
Size
Wrench Size
Pump drive shaft guard bolts
3/8-16
9/16
1/2-13
3/4
Pump drive shaft bolts
3/8-16
9/16
3/8-24
9/16
Upper articulation pin outer bolts
1/2-13
3/4
Lower articulation pin bottom cap bolts
5/8-11
15/16
Lower articulation pin outer bolts
1/2-13
3/4
Lower articulation pin retainer bolts
1/2-13
3/4
Articulation pin pusher bolts
1/2-13
3/4
Articulation cylinder pin cap bolts
3/8-24
9/16
Front frame cable clamp bolts
3/8-16
9/16
Remote control box storage attaching bolts
5/16-18
1/2
Solid tandem link cap bolts
3/8-16
9/16
Push-pull cable nuts
3/8
1/2
15/16
1
Bolt-on eyes
3/4-10
-
END OF WORK PACKAGE
0018 00-2
