Place a
Remove dipstick (20).
right
under
container
suitable
Remove drain plug
tandem housing.
(44) and allow oil to drain.
Dry cleaning solvent (P-D-
680) used to clean parts is
Use
toxic and flammable.
well
ventilated
only in
Wear
protective
areas.
Do not
goggles and gloves.
smoke or allow open flames
or sparks in areas where
cleaning solvent is used or
stored.
Avoid contact with
eyes, skin, and clothing.
If contact is made, flush
with cold water and seek
If you
medical attention.
become dizzy while
using
cleaning solvent, get fresh
air immediately.
for
used
Compressed
air
cleaning purposes will not
exceed 30 PSI.
Use only
with effective chip guarding
protective
and
personal
(goggles/shield,
equipment
gloves, etc.)
Clean breather and plug with SD-II.
Dry thoroughly with compressed air.
Install drain plug.
Fill housing
with oil.
Fill capacity is 17
gallons.
Start engine and operate vehicle for
a few minutes. Inspect for leaks.
Stop engine and check tandem drive oil
level. Maintain oil level between ADD
and FUEL on dipstick (20). Add oil if
necessary.
LO 5-3805-261-12
AS REQUIRED (Cont)
Card 28 of 30
