26. CIRCLE DRIVE HOUSING (0)
ANNUALLY
(Cont)
NOTE
The vehicle must be parked
on level ground with all
equipment
lowered to
the
ground, engine off and park-
ini brake applied
before
performing this procedure.
Place a
Remove fill plug (42).
suitable container under circle
drive housing. Remove drain plug
(43) and allow oil to drain.
Install drain plug.
Fill circle
drive
housing with oil.
Fill
capacity is 2 gallons. Install fill
Plug.
Start engine and operate vehicle for
a few minutes. Inspect for leaks.
stop engine and check lubricant
level.
Oil level must be within 1
inch of bottom of fill port.
Add
oil, if necessary.
27.
TANDEM DRIVE HOUSINGS (0)
Hot oil can cause burns and
SERIOUS INJURY.
Use care
when draining hot oil.
NOTE
The vehicle must be parked
on level ground with all
equipment
lowered to
the
ground,
engine
off
and
parking brake applied before
performing this procedure.
The following procedure is
for the right tandem hous-
ing.
The procedure for the
left
housing is
tandem
identical.
Card 27 of 3
ANNUALLY (Cont) AND AS REQUIRED
LO 5-3805-261-12
