TM 5-3805-293-23-5
0346
APPLYING TORQUE
000346
1. When tightening fasteners, use torque value as specified in Torque Limits (WP 0348).
2. If a unique torque value is required, it will be provided in a procedural step in the task.
3. If a unique torque pattern is required, it will be provided in a procedural step in the task.
END OF TASK
TAGGING INSTRUCTIONS
000346
1. Use marker tags to identify all electrical wires, fuel, oil, coolant, and hydraulic lines, as well as any other parts
that may be hard to identify or replace later. Fasten tags to parts during removal by wrapping wire fasteners
around or through parts and twisting ends together. Position tags to be out of the way during cleaning, inspec-
tion, and repair. Mark tags with a pencil, pen, or marker.
2. Whenever possible, identify electrical wires with the number of the terminal or wire to which they connect. If no
markings can be found, tag both wires, or wire and terminal, and use the same identifying mark for both. If you
cannot tag a wire because it must fit through a small hole or you cannot reach it, write down a description of the
wire and the point to which it connects, or draw a simple diagram on paper. Be sure to write down enough
information so that you can properly connect the wires during assembly. If you need to identify a loose wire,
look for an identifying number near the end of the wire, stamped on a permanent metal tag. Compare that
number to wire numbers on the appropriate electrical schematic.
3. Identify fuel, oil, coolant, and hydraulic lines when you are taking off more than one line at the same time. Mark
tags with points to which lines and hoses must be connected. If it is not obvious which end of a line goes
where, tag each end of the line.
4. Identify and tag other parts by name and installed location as required.
END OF TASK
FLUID DISPOSAL
000346
WARN I N G
When servicing equipment, performing mainte ance, or disposing of materials such as
n
engine coolant, hydraulic fluid, lubricants, battery acids or batteries, and CARC paint,
consult your unit/local hazardous waste disposal center or safety office for local regulatory
guidance. If further information is needed, please contact the Army Environmental Hotline
at 1-800-872-3845.
To prevent injury to personnel, wear protective eye covering and gloves.
Failure to follow these warnings ma result in injury to personnel.
y
Dispose of contaminated drained fluids IAW the Standard Operating Procedures (SOP) of your unit.
END OF TASK
END OF WORK PACKAGE
0346-8
