TM 5-3805-293-23-5
0318
REMOVAL CONTINUED
N OT E
Note the number of shims removed to aid in installation.
11. Remove four nuts (Figure 6, Item 2), washers (Figure 6, Item 3), housing (Figure 6, Item 4), shims (Figure 6,
Item 5), and O-ring (Figure 6, Item 6) from circle drive (Figure 6, Item 1). Discard O-ring.
Figure 6. Circle Drive Housing O-Ring.
0318
END OF TASK
CLEANING AND INSPECTION
000318
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0346).
END OF TASK
INSTALLATION
000318
N OT E
Install shims as needed to ensure housing is flush with circle drive.
Alternate the tightening of nuts to draw down housing.
1. Install new O-ring (Figure 6, Item 6), shims (Figure 6, Item 5), housing (Figure 6, Item 4), four washers
(Figure 6, Item 3), and nuts (Figure 6, Item 2) on circle drive (Figure 6, Item 1).