TM 5-3805-293-23-4
0257
REMOVAL
000257
N OT E
The procedures for re oving, cleaning, inspecting, installing, and adjusting the machine
m
articulation angle sensor 1 (left) and machine articulation angle sensor 2 (right) are
identical. The machine articulation angle sensor 2 (right) is shown in this procedure.
Tag harness and connector to aid in installation.
1. Disconnect secondary steering harness (Figure 1, Item 3) from electrical connector (Figure 1, Item 5) and
remove electrical connector (Figure 1, Item 5) from clip (Figure 1, Item 4).
2. Remove bolt (Figure 1, Item 11), washer (Figure 1, Item 10), link assembly (Figure 1, Item 12) and washer
(Figure 1, Item 8) from articulation pin (Figure 1, Item 9).
3. Remove two bolts (Figure 1, Item 1), washers (Figure 1, Item 2), mounting block assembly (Figure 1, Item 7)
and spacers (Figure 1, Item 6) from frame.
Figure 1. Mounting Block.
0257