TM 5-3805-293-23-4
0246
REMOVAL CONTINUED
000246
WARN I N G
Hydraulic oil is very slippery. Immediately wipe up any spills. Failure to follow this warning
may result in injury to personnel.
C AU T I O N
Cap all open lines and fittings to prevent dirt from entering system and to prevent leakage.
Keep all parts clean from contaminants. Contaminants may cause rapid wear and
shortened component life.
N OT E
Tag lines to aid in installation.
7. Remove two implement lines (Figure 2, Item 5) and O-rings (Figure 2, Item 4) from rear valve bank (Figure 2,
Item 1). Discard O-rings.
8. Remove four implement hoses (Figure 2, Item 2) and O-rings (Figure 2, Item 3) from rear valve bank (Figure 2,
Item 1). Discard O-rings.
9. Remove pump pressure output line (Figure 2, Item 22) and O-ring (Figure 2, Item 21) from rear valve bank
(Figure 2, Item 1). Discard O-ring.
10. Remove pilot/shutoff pressure outlet line (Figure 2, Item 20) and O-ring (Figure 2, Item 19) from rear valve
bank (Figure 2, Item 1). Discard O-ring.
11. Remove left return line (Figure 2, Item 16) and O-ring (Figure 2, Item 15) from rear valve bank (Figure 2,
Item 1). Discard O-ring.
12. Remove right return line (Figure 2, Item 13) and O-ring (Figure 2, Item 12) from rear valve bank (Figure 2,
Item 1). Discard O-ring.
13. Remove pilot/shutoff pressure inlet line (Figure 2, Item 17) and O-ring (Figure 2, Item 18) from rear valve bank
(Figure 2, Item 1). Discard O-ring.
14. Remove pilot/shutoff sense line (from front valve) (Figure 2, Item 8) and O-ring (Figure 2, Item 9) from rear
valve bank (Figure 2, Item 1). Discard O-ring.
15. Remove pilot/shutoff sense line (to load signal resolver shuttle valve) (Figure 2, Item 11) and O-ring (Figure 2,
Item 10) from rear valve bank (Figure 2, Item 1). Discard O-ring.
16. Remove pump pressure inlet line (Figure 2, Item 7) and O-ring (Figure 2, Item 6) from rear valve bank
(Figure 2, Item 1). Discard O-ring.
0246-4