TM 5-3805-293-23-3
0124
INSTALLATION
000124
N OT E
Install sprockets so that teeth on sprockets are offset from each other.
If reinstalling original spro kets, align alignment marks on sprockets as noted during
c
removal.
1. Install two sprockets (Figure 5, Item 3) on final drive (Figure 5, Item 2).
WARN I N G
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can
cause lung irritation. Contact with skin can cause dermatitis. Wear gloves and safety
goggles and use product in a well-ventilated area away from open flame. If ingested, keep
individual calm and seek medical attention. DO NOT induce vomiting. If contact with skin
or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW local policy and
ordinances. Failure to follow this warning may cause injury to personnel.
N OT E
If installing original sprockets, instal the same number of shims as removed.
l
If installing new sprockets, perform shim in tallation procedure in this work package.
s
Tandem housing may need to be repositioned to tighten bolts.
2. Apply sealing compound to three bolts.
3. Install shims (Figure 5, Item 5), retainer (Figure 5, Item 4), and three bolts (Figure 5, Item 6), on sprocket
(Figure 5, Item 3). Torque to 199 30 lb-ft (270 40 Nm).
4. Install new O-ring (Figure 5, Item 1) on final drive (Figure 5, Item 2).
Figure 5. O-ring on Sprocket Assembly.
0124