TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2201-04 Right Steering Cyl-
3. Using the MSD (WP 0006), select 2201-04 Code Active - Repeat
inder Position Sensor Volt-
Implement 120M and verify 2201- troubleshooting code from the
age Below Normal -
04 is not active.
beginning.
Continued
2201-04 Code Not Active -
Troubleshooting complete.
Test Step 6. Test for Shorted Front
Chassis Wiring Harness.
1. Disconnect the right steering cyl-
inder position sensor wiring har-
ness connector UC-C1 (WP 0009,
Figure 198) from front chassis wir-
ing harness U-C58 (WP 0009,
Figure 153) (WP 0136).
2. Using a digital multimeter, mea-
Continuity - Right steering cylinder
sure resistance between right
position sensor harness is shorted,
steering cylinder position sensor
replace right steering position sensor
wiring harness connector UC-C1
harness (WP 0136).
(WP 0009, Figure 198) terminal 3
Connect the front chassis wiring
and machine ground.
harness connector U-C1 (WP 0009,
There should be no continuity.
Figure 121) to cab lower wiring
harness P-C50 (WP 0009, Figure
120) (WP 0180).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Connect the rear chassis wiring
harness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring
harness connector FA-C22 (WP 0009,
Figure 47) to cab lower wiring harness
P-C69 (WP 0009, Figure 46).
Proceed to step 3.
0031-66
