TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2201-04 Right Steering Cyl-
Test Step 7. Test for Shorted Cab
inder Position Sensor Volt-
Lower Wiring Harness to Imple-
age Below Normal -
ment ECM.
Continued
harness is shorted, replace cab lower
lower wiring harness connector P-
wiring harness (WP 0266).
C39 (WP 0009, Figure 70) termi-
Connect the steering position sensor
nal 16 and machine ground.
harness UC-C2 (WP 0009, Figure
There should be no continuity.
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Connect the rear chassis wiring
harness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Proceed to step 2.
transmission ECM (WP 0137).
Connect the steering position sensor
harness UC-C2 (WP 0009, Figure
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 2.
2. Using the MSD (WP 0006), select
2201-04 Code Active - Repeat
Trans/chassis 120M and verify
troubleshooting code from the
2201-04 is not active.
beginning.
2201-04 Code Not Active -
Troubleshooting complete.
0031-68