TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-08 Left Steering Cylin-
4. Connect UA-C2 (WP 0009, Figure
der Position Sensor Abnor-
192) to right steering position sen-
mal Frequency, Pulse Width
sor (WP 0009, Figure 197).
or Period - Continued
5. Connect UC-C2 (WP 0009, Fig-
ure 196) to left steering position
sensor (WP 0009, Figure 193).
6. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
2201-08 Code Becomes Active -
7. Using the MSD (WP 0006), select
Implement 120M and check if
Disconnect UA-C2 (WP 0009, Figure
2201-08 becomes active.
192) from right steering position
sensor (WP 0009, Figure 197).
Disconnect UC-C2 (WP 0009, Figure
196) from left steering position sensor
(WP 0009, Figure 193).
Left steering position sensor is faulty,
replace left steering cylinder (WP
0169).
Connect the steering position sensor
harness UC-C2 (WP 0009, Figure
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Proceed to step 8.
2200-08 Code Remains Active -
Proceed to Test Step 3.
8. Using the MSD (WP 0006), select 2200-08 Code Active - Repeat
Implement 120M and verify 2200- troubleshooting code from the
08 is not active.
beginning.
2200-08 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Open Rear
Chassis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect UA-C2 (WP 0009,
Figure 192) from right steering
position sensor (WP 0006, Figure
197).
0031-32
