TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-04 Left Steering Cylin-
Test Step 6. Test for Shorted Cab
der Position Sensor Voltage
Lower Wiring Harness to Imple-
Below Normal - Continued
ment ECM.
1. Using a digital multimeter, mea-
Continuity - Cab lower wiring
sure resistance between cab
harness is shorted, replace cab lower
lower wiring harness connector P-
wiring harness (WP 0266).
C39 (WP 0009, Figure 70) termi-
Connect the steering position sensor
nal 15 and P-C41 (WP 0009, Fig-
harness UA-C2 (WP 0009, Figure
ure 68) terminal 70.
192) to left steering position sensor
There should be no continuity.
(WP 0009, Figure 193) (WP 0169).
Connect the rear chassis wiring
harness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring
harness connector FA-C20 (WP 0009,
Figure 113) to transmission ECM J1
(WP 0009, Figure 112).
Proceed to step 2.
Resistance 5.0 Ohms or Greater -
Replace transmission ECM (WP
0137).
Connect the steering position sensor
harness UA-C2 (WP 0009, Figure
192) to left steering position sensor
(WP 0009, Figure 193) (WP 0169).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 2.
2. Using the MSD (WP 0006), select 2200-04 Code Active - Repeat
Implement 120M and verify 2200- troubleshooting code from the
04 is not active.
beginning.
2200-04 Code Not Active -
Troubleshooting complete.
0031-30
