TM 5-3805-293-23-2
0029
Table 1. Implement Code (2160-03 TO 2168-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2168-06 Circle Right Sole-
Test Step 3. Test Cab Lower
noid Current Above Normal -
Harness.
Continued
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect front attachment har-
ness connector U-C1 (WP 0009,
Figure 121) from cab lower har-
ness connector P-C50 (WP 0009,
Figure 120).
3. Using digital multimeter, test for
Continuity - Replace front
continuity between harness con-
attachment wiring harness (WP
nector U-C1 (WP 0009, Figure
0180).
121) terminal 7 and all other ter-
Proceed to step 6.
minals on harness connector U-
No Continuity - Proceed to step 4.
C1.
There should be no continuity.
4. Disconnect cab lower harness
connector P-C45 (WP 0009, Fig-
ure 72) from implement 2 ECM J1
(WP 0009, Figure 73) (WP 0268).
5. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C45 (WP 0009, Figure
Connect front attachment harness
45) terminal 52 and all other ter-
connector U-C16 (WP 0009, Figure
minals on harness connector P-
252) to circle right solenoid (WP 0009,
C45 and to machine ground.
Figure 253), and install front frame
There should be no continuity.
nose cover (WP 0224).
Proceed to step 6.
No Continuity - Replace implement 2
ECM (WP 0268).
Connect cab lower harness connector
P-C45 (WP 0009, Figure 72) to
implement 2 ECM J1 (WP 0009,
Figure 73).
Connect front attachment harness
connector U-C1 (WP 0009, Figure
121) to cab lower harness connector
P-C50 (WP 0009, Figure 120).
Connect front attachment harness
connector U-C16 (WP 0009, Figure
252) to circle right solenoid (WP 0009,
Figure 253), and install front frame
nose cover (WP 0224).
Proceed to step 6.
0029-64