TM 5-3805-293-23-2
0029
Table 1. Implement Code (2160-03 TO 2168-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2160-06 Blade Left Raise
2. Disconnect front attachment har-
Solenoid Current Above
ness connector U-C1 (WP 0009,
Normal - Continued
Figure 121) from cab lower har-
ness connector P-C50 (WP 0009,
Figure 120).
3. Using digital multimeter, test for
Continuity - Replace front
continuity between harness con-
attachment wiring harness (WP
nector U-C1 (WP 0009, Figure
0180).
121) terminal 20 and all other ter-
Connect cab lower harness connector
minals on harness connector U-
P-C41 (WP 0009, Figure 68) to
C1.
implement 1 ECM J1 (WP 0009,
There should be no continuity.
Figure 69).
Proceed to step 6.
No Continuity - Proceed to step 4.
4. Disconnect cab lower harness
connector P-C41 (WP 0009, Fig-
ure 68) from implement 1 ECM J1
(WP 0009, Figure 69) (WP 0268).
5. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C41 (WP 0009, Figure
Connect front attachment harness
68) terminal 58 and all other ter-
connector U-C25 (WP 0009, Figure
minals on harness connector P-
242) to blade left raise solenoid (WP
C41 and to machine ground.
0009, Figure 243), and install rear
There should be no continuity.
front frame cover (WP 0224).
Proceed to step 6.
No Continuity - Replace implement 1
ECM (WP 0268).
Connect front attachment harness
connector U-C1 (WP 0009, Figure
121) to cab lower harness connector
P-C50 (WP 0009, Figure 120).
Connect front attachment harness
connector U-C25 (WP 0009, Figure
242) to blade left raise solenoid (WP
0009, Figure 243), and install rear
front frame cover (WP 0224).
Proceed to step 6.
6. Using MSD (WP 0006), select
2160-06 Code Active - Repeat
Implement 120M and verify 2160- troubleshooting code from the
06 is active.
beginning.
2160-06 Code Not Active -
Troubleshooting complete.
0029-8