TM 5-3805-293-23-2
0028
Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2155-04 Circle Drive Lever
Test Step 3. Test for Shorted Cab
Position Sensor Voltage
Lower Wiring Harness.
Below Normal - Continued
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J1 (WP 0009, Figure 69)
(WP 0266).
3. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J2 (WP 0009, Figure 71)
(WP 0266).
4. Using digital multimeter, measure
Continuity - Replace cab lower wiring
for continuity between cab lower
harness (WP 0266).
wiring harness connector P-C39
Proceed to step 5.
(WP 0009, Figure 70) terminal 32
No Continuity - Replace implement 1
and P-C41 terminal 70. There
ECM (WP 0268).
should be no continuity.
Connect cab lower wiring harness
connector PE-C8 (WP 0009, Figure
50) to RH joystick connector J1 (WP
0283).
Proceed to step 5.
5. Using MSD (WP 0006), select
2155-04 Code Active - Repeat
Implement 120M ECM and verify
troubleshooting code from the
2155-04 is not active.
beginning.
2155-04 Code Not Active -
Troubleshooting complete.
0028-73
