TM 5-3805-293-23-2
0028
Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2155-03 Circle Drive Lever
5. Using digital multimeter, test for
Voltage Between 9.6 to 10.4 Volts -
Position Sensor Voltage
voltage between harness connec-
Proceed to Test Step 5.
Above Normal - Continued
tor PE-C8 (WP 0009, Figure 50)
Voltage Out of Specifications of 9.6
terminal 6 and terminal 8 ground.
to 10.4 Volts - Proceed to Test Step 3.
Voltage should be between 9.6 to
10.4 volts.
Test Step 3. Test for Open Rear
Chassis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
3. Connect jumper wire between cab
lower wiring harness connector
PE-C8 (WP 0009, Figure 50) ter-
minal 6 and terminal 8.
4. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
for continuity between rear chas-
Replace implement 1 ECM (WP 0268)
sis wiring harness connector FA-
and transmission ECM (WP 0137).
C20 (WP 0009, Figure 113) termi-
Proceed to step 5.
nal 69 and terminal 70.
Resistance 5.0 Ohms or Greater -
Resistance should be less than
Proceed to Test Step 4.
5.0 ohms.
5. Using MSD (WP 0009), select
2155-03 Code Active - Repeat
Implement 120M ECM and verify
troubleshooting code from the
2155-03 is not active.
beginning.
2155-03 Code Not Active -
Troubleshooting complete.
0028-68