TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1472-04 Steering Control
Test Step 2. Test for Shorted Rear
Position Sensor #2 Voltage
Chassis Wiring Harness.
Below Normal - Continued
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
3. Disconnect the rear chassis wir-
ing harness connector FA-C21
(WP 0009, Figure 124) from
transmission ECM J2 (WP 0009,
Figure 112).
4. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J-2 (WP 0009, Figure 71)
(WP 0268).
No Continuity - Replace
wiring harness connector FA-C21
transmission ECM (WP 0137).
(WP 0009, Figure 124) terminal
Connect the cab lower wiring harness
48 and FA-C20 (WP 0009, Figure
connector P-C51 (WP 0009, Figure
113) terminal 45.
118) to LH joystick connector J-1 (WP
There should be no continuity.
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Proceed to step 6.
6. Using the MSD (WP 0006), select 1472-04 Code Active - Repeat
Implement 120M and verify 1472- troubleshooting code from the
04 is not active.
beginning.
1472-04 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Shorted Cab
Lower Wiring Harness.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) (WP 0188)
from cab lower wiring harness
connector P-C69 (WP 0009, Fig-
ure 46).
0027-84