TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1471-08 Steering Control
Resistance 5.0 Ohms or Greater -
Position Sensor #1 Abnor-
Cab lower wiring harness is open,
mal Frequency, Pulse Width
replace cab lower wiring harness (WP
or Period - Continued
0266).
Connect the rear chassis wiring
harness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring
harness connector FA-C20 (WP 0009,
Figure 113) (WP 0137) to
transmission ECM J1 (WP 0009,
Figure 112).
Proceed to step 2.
2. Using the MSD (WP 0006), select 1471-08 Code Active - Repeat
Implement 120M and verify 1471- troubleshooting code from the
08 is not active.
beginning.
1471-08 Code Not Active -
Troubleshooting complete.
Test Step 4. Test for Open Cab
Upper Wiring Harness to Imple-
ment ECM.
1. Remove jumper wire between P-
C51 terminal 2 and terminal 4
(WP 0009, Figure 118).
2. Connect jumper wire between P-
C51 terminal 2 and terminal 8
(WP 0009, Figure 118).
0027-65