TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1471-08 Steering Control
Test Step 1. Test for Signal Voltage
Position Sensor #1 Abnor-
at LH Joystick.
mal Frequency, Pulse Width
1. Connect MSD (WP 0006), select
or Period - Continued
Implement 120M and verify 1471-
08 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
position.
3. Disconnect the cab lower wiring
harness connector P-C51 (WP
0009, Figure 118) from LH joy-
stick connector J-1 (WP 0009,
Figure 119) (WP 0282).
4. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
5. Using digital multimeter, measure
Voltage OK (11.8 to 12.3 Volts) -
voltage between P-C51 terminal 2
Sensor signal circuit, transmission
(WP 0009, Figure 118) and termi-
and implement ECM OK. Replace LH
nal 8 (ground).
joystick (WP 0282).
Voltage should be 11.8 to 12.3 volts.
Proceed to step 6.
Voltage Not OK - Sensor signal
circuit shorted to ground or
transmission or implement ECM bad,
proceed to Test Step 2.
6. Using the MSD (WP 0006), select
1471-08 Code Active - Repeat
Trans/chassis 120M and verify
troubleshooting code from the
1471-08 is not active.
beginning.
1471-08 Code Not Active -
Troubleshooting complete.
Test Step 2. Test for Open Rear
Chassis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
3. Disconnect the rear chassis wir-
ing harness connector FA-C21
(WP 0009, Figure 124) from
transmission ECM J2 (WP 0009,
Figure 112).
0027-63
