TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1471-03 Steering Control
3. Disconnect the cab lower wiring
Position Sensor #1 Voltage
harness connector P-C51 (WP
Above Normal - Continued
0009, Figure 118) from LH joy-
stick connector J-1 (WP 0009,
Figure 119) (WP 0282).
4. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
5. Using digital multimeter, measure
Voltage OK (7.6 to 8.4 Volts) - 8 Volt
voltage between P-C51 terminal 1
power supply from implement ECM
(WP 0009, Figure 118) and termi-
and cab lower wiring harness OK,
nal 8 (ground).
proceed to step 6.
Voltage should be between 7.6 to 8.4
Voltage NOT OK - Proceed to Test
volts.
Step 2.
6. Using digital multimeter, measure
Voltage OK (11.8 to 12.3 Volts) -
voltage between P-C51 terminal 2
Sensor signal circuit, transmission
(WP 0009, Figure 118) and termi-
and implement ECM OK. Replace LH
nal 8 (ground).
joystick (WP 0282).
Voltage should be 11.8 to 12.3 volts.
Proceed to step 7.
Voltage Not OK - Sensor signal
circuit open or transmission or
implement ECM bad, proceed to Test
Step 3.
7. Using the MSD (WP 0006), select 1471-03 Code Active - Repeat
Implement 120M and verify 1471- troubleshooting code from the
03 is not active.
beginning.
1471-03 Code Not Active -
Troubleshooting complete.
Test Step 2. Test for Open Cab
Lower Wiring Harness to 8 Volt
Power Supply.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Connect jumper wire between P-
C51 terminal 1 and terminal 8
(WP 0009, Figure 118).
3. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J-1 (WP 0009, Figure 69)
(WP 0268).
0027-55
