TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1471-02 Steering Control
4.
Using digital multimeter, test for
Continuity - Proceed to Test Step 5.
Position Sensor #1 Data
continuity between rear chassis
No Continuity and 1471-02 Code
Erratic, Intermittent or Incor-
wiring harness connector FA-C21
Present on Trans/Chassis ECM and
rect - Continued
(WP 0009, Figure 124) terminal
Implement ECM - Proceed to Test
18, and all other terminals, and
Step 6.
machine ground.
No Continuity and 1471-02 Code
There should be no continuity.
Present on Trans/Chassis ECM
Only - Transmission ECM faulty,
replace transmission ECM (WP
0137).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 5.
5. Using the MSD (WP 0006), select 1471-02 Code Active - Repeat
Implement 120M and verify 1471- troubleshooting code from the
02 is not active.
beginning.
1471-02 Code Not Active -
Troubleshooting complete.
Test Step 5. Test for Shorted Cab
Lower Wiring Harness.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) (WP 0188)
from cab lower wiring harness
connector P-C69 (WP 0009, Fig-
ure 46).
0027-52