TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0041-04 8 Volt DC Supply
19. Using MSD (WP 0006), select
0041-04 Code Active - Repeat
Voltage Below Normal - Con-
Implement 120M ECM and verify
troubleshooting code from the
tinued
0041-03 is active
beginning.
0041-04 Code Not Active -
Troubleshooting complete.
Test Step 2. Test Secondary Steer-
ing Sensor Harness.
1. Disconnect harness connector
FA-C5 (WP 0009, Figure 111)
from harness connector AT-C1
(WP 0009, Figure 110) (WP
0186).
2. Using digital multimeter, test for
Continuity - Replace rear chassis
continuity between harness con-
wiring harness (WP 0188).
nector FA-C20 (WP 0009, Figure
Connect harness connector AT-C4
113) terminal 44 and all other ter-
(WP 0009, Figure 122) to right
minals on FA-C20 and to machine
articulation angle position sensor (WP
ground.
0009, Figure 123) (WP 0257).
There should be no continuity.
Connect harness connector FA-C23
(WP 0009, Figure 17) to harness
connector P-C71 (WP 0009, Figure
18), and install rear bulkhead
connection cover (WP 0266).
Proceed to step 3.
No Continuity - Replace secondary
steering harness (WP 0186).
Connect harness connector FA-C20
(WP 0009, Figure 113) to
transmission ECM J1 (WP 0137).
Connect harness connector AT-C4
(WP 0009, Figure 122) to right
articulation angle position sensor (WP
0009, Figure 123) (WP 0257).
Connect harness connector FA-C23
(WP 0009, Figure 17) to harness
connector P-C71 (WP 0009, Figure
18), and install rear bulkhead
connection cover (WP 0266).
Proceed to step 3.
3. Using MSD (WP 0006), select
0041-04 Code Active - Repeat
Implement 120M ECM and verify
troubleshooting code from the
0041-03 is active.
beginning.
0041-04 Code Not Active -
Troubleshooting complete.
0026-10
