TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0041-04 8 Volt DC Supply
18. Using MSD select Implement
0041-04 is Not Active - Replace left
Voltage Below Normal - Con-
120M ECM and monitor diagnos-
hand joystick (WP 0282).
tinued
tic code 0041-04 while connecting
Connect harness connector P-C40
harness connector P-C40 (WP
(WP 0009, Figure 144) to inching
0009, Figure 144) to inching pedal
pedal position sensor (WP 0009,
position sensor (WP 0009, Figure
Figure 145) (WP 0257).
145) (WP 0257).
Install inching pedal assembly cover
(WP 0290).
Install rear bulkhead cover plate (WP
0266).
Connect harness connector AT-C4
(WP 0009, Figure 122) to right
articulation angle position sensor (WP
0009, Figure 123) (WP 0257).
Proceed to step 19.
0041-04 Becomes Active - Replace
inching pedal position sensor (WP
0289).
Connect harness connector AT-C4
(WP 0009, Figure 122) to right
articulation angle position sensor (WP
0009, Figure 123) (WP 0257).
Connect harness connector P-C48
(WP 0009, Figure 116) on left hand
joystick J3 (WP 0009, Figure 117).
Install inner panel cover on left
joystick support (WP 0282).
Install operator's seat (WP 0284).
Install rear bulkhead cover plate (WP
0266).
Proceed to step 19.
0026-9