TM 5-3805-293-23-2
0024
Table 1. Window Wipers and Washers Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. RH Door Wiper Does Not
5. Turn right door wiper/washer con- Right Door Wiper Does Not Work in
Operate Properly - Con-
trol to LOW, HIGH, and PARK
One Or More Positions Or Does Not
tinued
position (TM 5-3805-293-10).
Return To Park - Repeat trouble-
shooting from beginning.
Right Door Wiper Works In Low,
and High Position, and Returns to
Park - Troubleshooting complete.
Test Step 7. Inspect Ground Points
of Cab Lower Wiring Harness.
Ground Point or Ring Terminal
1. Inspect ground points of cab
Dirty or Corroded - Clean as neces-
lower wiring harness (WP 0009,
sary.
Figure 65) for dirt, corrosion, and
damage.
Connect P-C3 (WP 0009, Figure 34)
on R-C1 (WP 0009, Figure 33) (WP
0266).
Connect R-C32 (WP 0009, Figure
363) on RH door wiper washer switch
(WP 0274).
Install cover on fuse box (TM 5-3805-
293-10).
Proceed to step 2.
Ring Terminal Defective - Replace
cab lower wiring harness (WP 0266).
Connect R-C32 (WP 0009, Figure
363) on RH door wiper washer switch
(WP 0274).
Install cover on fuse box (TM 5-3805-
293-10).
Proceed to step 2.
No Problem Found - Install cab lower
wiring harness terminals on ground
point with mounting hardware and
tighten securely.
Proceed to Test Step 8.
2. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-3805-293-10).
3. Turn right door wiper/washer con- Right Door Wiper Does Not Work in
One Or More Positions Or Does Not
trol to LOW, HIGH, and PARK
Return To Park - Repeat trouble-
position (TM 5-3805-293-10).
shooting from beginning.
Right Door Wiper Works In Low,
and High Position, and Returns to
Park - Troubleshooting complete.
0024-55
