TM 5-3805-293-23-2
0023
Table 1. Cab Electrical Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
14. Right Position Light and/
Resistance More Than 5.0 Ohms -
or Tail Light Does Not
Replace control indicator wiring har-
Operate - Continued
ness (WP 0283).
Install dimmer relay (WP 0009, Figure
296) on fuse panel.
Install headlamp relay (WP 0009, Fig-
ure 298) on fuse panel.
Connect the front work light wiring
harness connector CL-C24 (WP 0009,
Figure 393) to front lighting wiring har-
ness connector A-C4 (WP 0009, Fig-
ure 394) (WP 0196).
Connect the front work light wiring
harness connector CL-C26 (WP 0009,
Figure 293) to front lighting wiring har-
ness connector A-C3 (WP 0009, Fig-
ure 292) (WP 0196).
Connect the connector AA-C2 (WP
0009, Figure 291) to right headlight.
Connect the connector AZ-C6 (WP
0009, Figure 392) to right headlight
and install headlight assembly (WP
0197).
Proceed to step 15.
15. Turn control indicator switch to
Right Position Light and/or Tail
position SER. DRIVE and Park
Light Do Not Operate - Repeat trou-
(TM 5-3805-293-10). Visually
bleshooting from the beginning.
check if right tail light and right
Right Position Light and/or Tail
position light operate.
Light Operate - Troubleshooting
complete.
Test Step 5. Check for Faulty Rear
Lamps Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect the rear lamps har-
ness connector AG-C20 (WP
0009, Figure 311) from rear chas-
sis wiring harness connector FA-
C29 (WP 0009, Figure 310) (WP
0178).
0023-85
