TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-03 Left Steering Cylin-
2. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
der Position Sensor Voltage
resistance between cab lower wir-
Rear chassis wiring harness is open,
Above Normal - Continued
ing harness connector P-C69
replace rear chassis wiring harness
(WP 0009, Figure 46) terminal 47
(WP 0188).
and terminal 27. Resistance
Remove jumper wire from UA-C2 (WP
should be less than 5.0 Ohms.
0009, Figure 192) terminal 2 and ter-
minal 3.
Connect the steering position sensor
harness UA-C2 (WP 0009, Figure
192) to left steering position sensor
(WP 0009, Figure 193) (WP 0169).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Proceed to Test Step 5.
3. Using the MSD (WP 0006), select
2200-03 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2200-03 is not active.
2200-03 Code Not Active - Trouble-
shooting complete.
Test Step 5. Test for Open Front
Attachment Wiring Harness.
1. Disconnect the front attachment
wiring harness connector U-C36
(WP 0009, Figure 188) from cab
lower wiring harness P-C151 (WP
0009, Figure 189) (WP 0180).
0020-49