TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-08 Steering Control
Test Step 2. Test for Open Rear
Position Sensor #3 Abnor-
Chassis Wiring Harness.
mal Frequency, Pulse Width
1. Turn ignition switch and battery
or Period - Continued
disconnect switch to the OFF
position.
2. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
3. Disconnect the rear chassis wir-
ing harness connector FA-C21
(WP 0009, Figure 124) from
transmission ECM J2 (WP 0009,
Figure 112).
4. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J-2 (WP 0009, Figure 71)
(WP 0268).
5. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J-1 (WP 0009, Figure 69)
(WP 0268).
6. Disconnect the cab lower wiring
harness connector P-C51 (WP
0009, Figure 118) from LH joy-
stick connector J-1 (WP 0009,
Figure 117) (WP 0282).
7. Connect jumper wire between P-
C48 (WP 0009, Figure 116) termi-
nal 1 and P-C51 (WP 0009, Fig-
ure 118) terminal 3.
8. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between rear chassis
Proceed to Test Step 4.
wiring harness connector FA-C21
Resistance 5.0 Ohms or Greater -
(WP 0009, Figure 124) terminal
Proceed to Test Step 3.
34 and FA-C20 (WP 0009, Figure
113) terminal 21.
Resistance should be less than
5.0 ohms.
0019-64