TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1472-14 Steering Control
4. Using the MSD (WP 0006), select
1472-14 Code Active - Repeat trou-
Position Sensor #2 Special
Trans/chassis 120M and verify
bleshooting code from the beginning.
Instruction - Continued
1472-14 is not active.
1472-14 Code Not Active - Trouble-
shooting complete.
1473-02 Steering Control
System Response:
Position Sensor #3 Data
ECM will log a diagnostic code and a
Erratic, Intermittent or Incor-
warning will appear on the messenger
rect
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Check for Other Codes.
1. Connect MSD (WP 0006), select
Trans/chassis 120M and verify
1473-02 is active.
2. Check for Active code 1473-02
Code 1473-02 Active on Both
Implement 120M ECM (WP
Trans/Chassis and Implement
ECMs - Take note that both ECMs
have code active and proceed to step
3.
Code 1473-02 Active on Trans/
Chassis ECM Only - Take note that
only trans/chassis ECM has code
active and proceed to step 3.
Only Code 1473-02 Active - Proceed
3. Check for Active code 0041-03 or
to Test Step 2.
0041-04 in Trans/chassis 120M
ECM (WP 0006).
Trans/chassis 120M ECM Code
0041-03 or 0041-04 Active - 8 Volt
power supply abnormal voltage, trou-
bleshoot Trans/chassis 120M ECM
Code 0041-03 or 0041-04 first before
proceeding.
Test Step 2. Test for 8 V Power and
Signal Voltage at LH Joystick.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.