TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1472-14 Steering Control
4. Using digital multimeter, measure
Voltage OK (7.2 - 8.8 Volts) - Sensor
Position Sensor #2 Special
voltage between P-C51 terminal 7
signal circuit, transmission and imple-
Instruction - Continued
(WP 0009, Figure 118) and termi-
ment ECM OK. Replace LH joystick
nal 8 (ground). Voltage should be
(WP 0282).
between 7.2 - 8.8 volts.
Proceed to step 5.
Voltage Not OK - Sensor signal cir-
cuit shorted to ground or transmission
or implement ECM bad, proceed to
Test Step 3.
1472-14 Code Active - Repeat trou-
5. Using the MSD (WP 0006), select
bleshooting code from the beginning.
Trans/chassis 120M and verify
1472-14 is not active.
1472-14 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test for Open Rear
Chassis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
3. Disconnect the rear chassis wir-
ing harness connector FA-C21
(WP 0009, Figure 124) from
transmission ECM J2 (WP 0009,
Figure 112).
4. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J-2 (WP 0009, Figure 71)
(WP 0268).
5. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J-1 (WP 0009, Figure 69)
(WP 0268).
6. Connect jumper wire between P-
C51 terminal 7 and terminal 4
(WP 0009, Figure 118).
0019-43