TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-02 Steering Control
4.
Disconnect the rear chassis wir-
Position Sensor #3 Data
ing harness connector FA-C20
Erratic, Intermittent or Incor-
(WP 0009, Figure 113) from trans-
rect - Continued
mission ECM J1 (WP 0009, Fig-
ure 112).
5. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between FA-C20 (WP
Replace transmission ECM (WP
0137).
0009, Figure 113) terminal 44 and
terminal 21 (WP 0009, Figure 18).
Remove jumper wire between P-C48
Resistance should be less than
terminal 2 (WP 0009, Figure 116) and
5.0 ohms.
P-C51 terminal 3 (WP 0009, Figure
118).
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Proceed to step 6.
Resistance 5.0 Ohms or Greater -
Proceed to Test Step 4.
6. Using the MSD (WP 0006), select
1473-02 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1473-02 is not active.
1473-02 Code Not Active - Trouble-
shooting complete.
Test Step 4. Test for Cab Lower Wir-
ing Harness to 8 Volt Power Supply.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) (WP 0188)
from cab lower wiring harness
connector P-C69 (WP 0009, Fig-
ure 46).
2. Disconnect the rear chassis wir-
ing harness connector FA-C23
(WP 0009, Figure 17) (WP 0188)
from cab lower wiring harness
connector P-C71 (WP 0009, Fig-
ure 18).
0019-48