TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1472-08 Steering Control
System Response:
Position Sensor #2 Abnor-
ECM will log a diagnostic code and a
mal Frequency, Pulse Width
warning will appear on the messenger
or Period
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test for Signal Voltage
at LH Joystick.
1. Connect MSD (WP 0006), select
Trans/chassis 120M and verify
1472-04 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
position.
3. Disconnect the cab lower wiring
harness connector P-C51 (WP
0009, Figure 118) from LH joy-
stick connector J-1 (WP 0009,
Figure 119) (WP 0282).
4. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
5. Using digital multimeter, measure
Voltage OK (7.2 - 8.8 Volts) - Sensor
voltage between P-C51 terminal 7
signal circuit, transmission and imple-
(WP 0009, Figure 118) and termi-
ment ECM OK. Replace LH joystick
nal 8 (ground). Voltage should be
(WP 0282).
between 7.2 - 8.8 volts.
Proceed to step 6.
Voltage Not OK - Sensor signal cir-
cuit shorted to ground or transmission
or implement ECM bad, proceed to
Test Step 2.
6. Using the MSD (WP 0006), select
1472-08 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1472-08 is not active.
1472-08 Code Not Active - Trouble-
shooting complete.
