TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1472-04 Steering Control
Test Step 3. Test for Shorted Cab
Position Sensor #2 Voltage
Lower Wiring Harness.
Below Normal - Continued
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) (WP 0188)
from cab lower wiring harness
connector P-C69 (WP 0009, Fig-
ure 46).
2. Using digital multimeter, measure
Continuity - Cab lower wiring har-
resistance between cab lower wir-
ness is shorted, replace cab lower wir-
ing harness connector P-C69
ing harness (WP 0266).
(WP 0009, Figure 46) terminal 56
Connect the rear chassis wiring har-
and terminal 45. There should be
ness connector FA-C20 (WP 0009,
no continuity.
Figure 113) (WP 0154) to transmis-
sion ECM J1 (WP 0009, Figure 112).
Connect the rear chassis wiring har-
ness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Proceed to step 3.
No Continuity - Rear chassis wiring
harness is shorted, replace rear chas-
sis wiring harness (WP 0188).
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Proceed to step 3.
3. Using the MSD (WP 0006), select
1472-04 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1472-04 is not active.
1472-04 Code Not Active - Trouble-
shooting complete.
0019-37