TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0967-09 Monitoring System
4. Install a jumper wire between har-
Display Abnormal Update
ness connector FA-C22 (WP
Rate - Continued
0009, Figure 47) terminal 64 and
terminal 65.
5. Using digital multimeter, test for
Continuity - Proceed to step 6.
continuity between harness con-
No Continuity - Replace rear chassis
nector FA-C20 (WP 0009, Figure
wiring harness (WP 0188).
113) terminal 10 and terminal 20.
Connect cab lower wiring harness
Resistance should be less than
connector P-C93 (WP 0009, Figure
5.0 ohms.
163) to messenger (WP 0009, Figure
164) (WP 0272).
Proceed to step 8.
6. Remove jumper wire from har-
ness connector FA-C22 (WP
0009, Figure 47) terminal 10 and
terminal 20.
7. Using digital multimeter, test con-
Continuity - Replace cab lower wiring
tinuity between harness connec-
harness (WP 0266).
tor FA-C20 (WP 0009, Figure 113)
Connect harness connector FA-C20
terminal 10 and all other circuits
(WP 0009, Figure 113) to transmis-
on harness connector FA-C20
sion ECM J1 (WP 0009, Figure 112).
and to machine ground.
Proceed to step 8.
There should be no continuity.
No Continuity - Replace messenger
(WP 0272).
Proceed to step 8.
8. Using MSD (WP 0006), select
0967-09 Code Remains Active -
Trans/Chassis 120M and verify
Repeat troubleshooting from the
0967-09 is not active.
beginning of this diagnostic code.
0967-09 Code Not Active - Trouble-
shooting complete.
END OF WORK PACKAGE
0017-123/(124 blank)