TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0623-03 Directional Switch
16. Disconnect harness connector P-
Voltage Above Normal -
C52 (WP 0009, Figure 154) from
Continued
left hand joystick J2 (WP 0282).
17. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C69 (WP 0009, Figure
Connect harness connector FA-C21
46) terminal 50 and all other ter-
(WP 0009, Figure 124) to transmis-
minals on harness connector P-
sion ECM J2 (WP 0009, Figure 112).
C69.
Proceed to step 25.
There should be no continuity.
No Continuity - Proceed to step 18.
18. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C69 (WP 0009, Figure
Connect harness connector FA-C21
46) terminal 57 and all other ter-
(WP 0009, Figure 124) to transmis-
minals on harness connector P-
sion ECM J2 (WP 0009, Figure 112).
C69.
Proceed to step 25.
There should be no continuity.
No Continuity - Proceed to step 19.
19. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C69 (WP 0009, Figure
Connect harness connector FA-C21
46) terminal 41 and all other ter-
(WP 0009, Figure 124) to transmis-
minals on harness connector P-
sion ECM J2 (WP 0009, Figure 112).
C69.
Proceed to step 25.
There should be no continuity.
No Continuity - Proceed to step 20.
20. Install a jumper wire between har-
ness connector P-C52 (WP 0009,
Figure 154) terminal 9 and termi-
nal 10.
21. Using digital multimeter, test for
Resistance 5.0 Ohms or Less - Pro-
continuity between harness con-
ceed to step 22.
nector P-C69 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
46) terminal 50 and terminal 57.
Replace cab lower wiring harness
Resistance should be less than
(WP 0266).
5.0 ohms.
Connect harness connector FA-C21
(WP 0009, Figure 124) to transmis-
sion ECM J2 (WP 0009, Figure 112).
Proceed to step 25.
22. Remove jumper wire from har-
ness connector P-C52 (WP 0009,
Figure 154) terminal 9 and termi-
nal 10.
0017-88