TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0623-03 Directional Switch
6. Using digital multimeter, test for
Continuity - Replace rear chassis
Voltage Above Normal -
continuity between harness con-
wiring harness (WP 0188).
Continued
nector FA-C21 (WP 0009, Figure
Proceed to step 25.
124) terminal 28 and all other ter-
No Continuity - Proceed to step 7.
minals on FA-C21.
There should be no continuity.
7. Using digital multimeter, test for
Continuity - Replace rear chassis
continuity between harness con-
wiring harness (WP 0188).
nector FA-C21 (WP 0009, Figure
Proceed to step 25.
124) terminal 29 and all other ter-
No Continuity - Proceed to step 8.
minals on FA-C21.
There should be no continuity.
8. Install a jumper wire between har-
ness connector FA-C21 (WP
0009, Figure 124) terminal 23 and
terminal 28.
9. Using digital multimeter, test for
Resistance 5.0 Ohms or Less - Pro-
continuity between harness con-
ceed to step 10.
nector FA-C22 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
47) terminal 50 and terminal 57.
Replace rear chassis wiring harness
Resistance should be less than
(WP 0188).
5.0 ohms.
Proceed to step 25.
10. Remove jumper wire from har-
ness connector FA-C21 (WP
0009, Figure 124) terminal 23 and
terminal 28.
11. Install a jumper wire between har-
ness connector FA-C21 (WP
0009, Figure 124) terminal 28 and
terminal 29.
12. Using digital multimeter, test for
Resistance 5.0 Ohms or Less - Pro-
continuity between harness con-
ceed to step 13.
nector FA-C22 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
47) terminal 41 and terminal 57.
Replace rear chassis wiring harness
Resistance should be less than
(WP 0188).
5.0 ohms.
Proceed to step 25.
13. Remove jumper wire from har-
ness connector FA-C21 (WP
0009, Figure 124) terminal 28 and
terminal 29.
14. Remove operator's seat (WP
0284).
15. Remove inner panel cover from
left joystick support (WP 0282).
0017-87