TM 5-3805-293-23-1
0015
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2319-02 Left Front Drive
2. Using the MSD (WP 0006),
2319-02 Code Active - Repeat
Motor Speed Sensor #1
select All Wheel Drive 120M and
troubleshooting code from the
Data Erratic, Intermittent or
verify 2319-02 is not active.
beginning.
Incorrect - Continued
2319-02 Code Not Active - Trouble-
shooting complete.
2320-02 Left Front Drive
System Response:
Motor Speed Sensor #2
All-Wheel Drive (AWD) Electronic
Data Erratic, Intermittent or
Control Module (ECM) will log a diag-
Incorrect
nostic code and a warning will
appear on the messenger while the
diagnostic code is Active.
N OT E
Always inspect the harness connectors that are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is Active before performing this procedure.
Perform open or short circuit test at each harness connection to
identify correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test 8-Volt Supply Cir-
cuit and 8-Volt Return Circuit
Function.
1. Connect MSD (WP 0006). Select
All Wheel Drive 120M and verify
2320-02 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
position.
3. Disconnect left motor speed AK-
C2 harness connector (WP
0009, Figure 59) from left front
drive motor speed sensor con-
nector (WP 0009, Figure 60)
(WP 0166).
4. Connect jumper wire between
AK-C2 terminal 1 and AK-C2 ter-
minal 2 (WP 0009, Figure 59).
5. Turn battery disconnect switch
and ignition switch to the ON
position.