TM 5-3805-293-23-1
0015
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2320-02 Left Front Drive
Test Step 3. Test for Open Clutch
Motor Speed Sensor #2
Drive Solenoid Harness.
Data Erratic, Intermittent or
1. Turn ignition switch and battery
Incorrect - Continued
disconnect switch to the OFF
position.
2. Remove jumper wire from AF-C2
terminal 1 and terminal 2 (WP
0009, Figure 63).
3. Remove rear front frame cover
from machine (WP 0224).
4. Disconnect clutch drive solenoid
AF-C3 harness connector (WP
0009, Figure 51) from cab lower
wiring P-C34 harness connector
(WP 0009, Figure 52) (WP
0200).
5. Connect jumper wire between P-
C34 terminal 20 and P-C34 ter-
minal 21 (WP 0009, Figure 52).
6. Turn battery disconnect switch
and ignition switch to the ON
position.
7. Check for Active code 0041-04 in
Code 0041-04 Does Not Become
All Wheel Drive 120M ECM (WP
Active to step 8.
8. Perform Speed Sensor Test (WP
Motor Speeds Not OK, 2320-02
0023) and verify motors speeds
Code Active - Repeat
are 920 50 rpm in forward and -
troubleshooting code from the
920 50 rpm in reverse.
beginning.
Motor Speeds OK and 2320-02
Code Not Active - Troubleshooting
complete.
Test Step 4. Test 8-Volt Supply Cir-
cuit for High Resistance or Open
in Cab Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Remove jumper wire from P-C34
terminal 20 and terminal 21 (WP
0009, Figure 52).
0015-22
