TM 5-3805-293-23-1
0015
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2319-02 Left Front Drive
Test Step 4. Test 8-Volt Supply Cir-
Motor Speed Sensor #1
cuit for High Resistance or Open
Data Erratic, Intermittent or
in Cab Lower Wiring Harness.
Incorrect - Continued
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Remove jumper wire from P-C34
terminal 20 and terminal 21 (WP
0009, Figure 52).
3. Disconnect cab lower wiring P-
C35 harness connector (WP
0009, Figure 53) from AWD ECM
J1 (WP 0009, Figure 54) (WP
0270).
4. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
Proceed to Test Step 5.
sure resistance between P-C35
terminal 44 (WP 0009, Figure 53)
Resistance 5.0 Ohms or Greater -
and P-C34 terminal 20 (WP
Replace cab lower wiring harness
0009, Figure 52).
(WP 0266).
Connect AF-C2 (WP 0009, Figure
63) on AK-C1 (WP 0009, Figure 64).
Install nose front frame cover on
machine (WP 0224).
Connect AK-C2 (WP 0009, Figure
59) on left front drive motor speed
sensor connector (WP 0009, Figure
60) (WP 0166).
Proceed to step 5.
5. Perform Speed Sensor Test (WP
Motor Speeds Not OK, 2319-02
0023) and verify motors speeds
Code Active - Repeat
are 920 50 rpm in forward and -
troubleshooting code from the
920 50 rpm in reverse.
beginning.
Motor Speeds OK and 2319-02
Code Not Active - Troubleshooting
complete.
0015-5