TM 5-3805-293-23-1
0014
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2297-05 Right Front Drive
Test Step 6. Test PWM Driver
Pump Forward Control Sole-
Return Circuit for High Resistance
noid Current Below Normal -
or Open in Cab Lower Wiring Har-
Continued
ness.
1. Using a digital multimeter, mea-
Resistance 5.0 Ohms or Greater -
sure resistance between P-C35
Replace cab lower wiring harness
terminal 50 (WP 0009, Figure 55)
(WP 0266).
and P-C71 terminal 12 (WP 0009,
Connect AC-C5 (WP 0009, Figure 78)
Figure 18).
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AX-C1 (WP 0009, Figure
100) on AC-C1 (WP 0009, Figure
101).
Connect AX-C5 (WP 0009, Figure
106) on right drive pump forward sole-
noid connector (WP 0009, Figure 107)
and close access door.
Install front engine enclosure access
panel (WP 0226).
Proceed to step 2.
Resistance Less Than 5.0 Ohms -
Replace AWD ECM (WP 0270).
Connect FA-C23 (WP 0009, Figure
17) on P-C71 (WP 0009, Figure 18)
(WP 0188).
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AX-C1 (WP 0009, Figure
100) on AC-C1 (WP 0009, Figure
101).
Connect AX-C5 (WP 0009, Figure
106) on right drive pump forward sole-
noid connector (WP 0009, Figure 107)
and close access door.
Install front engine enclosure access
panel (WP 0226).
Proceed to step 2.
2. Using the MSD (WP 0006), select
2297-05 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2297-05 is not active.
2297-05 Code Not Active - Trouble-
shooting complete.
0014-83