TM 5-3805-293-23-1
0014
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2297-05 Right Front Drive
Test Step 5. Test Right Front Drive
Pump Forward Control Sole-
Pump Forward Control Solenoid
noid Current Below Normal -
Circuit for High Resistance or Open
Continued
in Cab Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Remove jumper wire from P-C71
terminal 15 and terminal 12 (WP
0009, Figure 18).
3. Disconnect cab lower wiring P-
C35 harness connector (WP
0009, Figure 53) from AWD ECM
J1 (WP 0009, Figure 54) (WP
0270).
4. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
Proceed to Test Step 6.
sure resistance between P-C35
terminal 51 (WP 0009, Figure 55)
Resistance 5.0 Ohms or Greater -
and P-C71 terminal 15 (WP 0009,
Replace cab lower wiring harness
Figure 18).
(WP 0266).
Connect AC-C5 (WP 0009, Figure 78)
on FA-C37 (WP 0009, Figure 79) (WP
0199).
Connect AX-C1 (WP 0009, Figure
100) on AC-C1 (WP 0009, Figure
101).
Connect AX-C5 (WP 0009, Figure
106) on right drive pump forward sole-
noid connector (WP 0009, Figure 107)
and close access door.
Install front engine enclosure access
panel (WP 0226).
Proceed to step 5.
5. Using the MSD (WP 0006), select
2297-05 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2297-05 is not active.
2297-05 Code Not Active - Trouble-
shooting complete.
0014-82